
- #UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER INSTALL#
- #UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER SOFTWARE#
- #UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER SERIES#
#UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER INSTALL#
We recommend that you install the FUS image to upgrade components such as the bootloader, field recovery image, FPGA/MCU, and other firmware to their latest respective versions.” From the release notes of FUS 1.9.0.0
#UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER SOFTWARE#
“Cisco Wireless LAN Controller (WLC) Field Upgrade Software (FUS) is a special AES package that performs various system-related component upgrades. Similarly, when the beacon interval is configured for 20 milliseconds, these APs transmit beacons every 17 milliseconds.What is a FUS or Field Upgrade Software? Do I need it? And what happens if I don’t have it installed. When these APs are configured for a 100-millisecond beacon interval, they transmit beacons every 102 milliseconds.
#UPDATING SOFTWARE ON CISCO WIRELESS ACCESS CONTROLLER SERIES#
Note The 1250 series access points have a hardware limitation where beacons can only be output at intervals that are multiples of 17 milliseconds. To see the type of radio module installed in your access point, enter this command on the access point: show controller dot11radio n, where n is the number of the radio (0 or 1). The AIR-RM20A radio, which was included in early 1200 series access point models, is not supported. Note Only Cisco Aironet 1200 Series Access Points that contain 802.11g (AIR-MP21G) or second-generation 802.11a radios (AIR-RM21A or AIR-RM22A) are supported for use with controller software releases. Note The AP802 is an integrated access point on the Next Generation Cisco 880 Series Integrated Services Routers (ISRs). Note The AP801 is an integrated access point on the Cisco 800 Series Integrated Services Routers (ISRs). Note Controller software release 5.0.148.0 or later is not compatible with Cisco Aironet 1000 series access points. Note This release does not support Cisco Aironet 15 access points.

Note The 7.0.116.0 release does not support the NM-AIR-WLC6 platform.



Location appliance software release 6.0.202.0.Cisco Wireless Control System (WCS) software release 7.0.172.0.Cisco autonomous to lightweight mode upgrade tool release 3.0.Software release 7.0.116.0 for all Cisco controllers and lightweight access points.The following components are part of the Cisco UWN Solution and are compatible in this release: We have many AP's that were converted that are now working fine on our 5508's Ĭisco Unified Wireless Network Solution Components Yes, a 1242 converted from Autonomous would be supported on the 5508
